Terms and Definitions


QFP Removal SX-100 Wrap

SX-100 Sodr-X-Tractor
SX-100 Sodr-X-Tractor

1. Remove conformal coating (if any) and clean work of any contamination, oxides or residues.

2. Set a tip temperature of 343°C (650°F) for lead-free or 316°C (600°F) for leaded alloys and adjust as necessary.

3. Install TQFP removal Pik-Tip® and vacuum cup into the SX-100 using Tip Tool.

4. Tack solder to one of the component corner leads.

5. Wrap solder around the four sides of component. (A)

6. Terminate solder at the end of last side.

7. Remove old solder from TQFP removal Pik-Tip® with Fiber Tool from Tip Maintenance Station.

8. Thermal shock tip with damp Sponge Tool from Tip Maintenance Station.

9. Tin inside and bottom edges of tip with solder. (B)

10. Lower tip over component contacting ALL leads with tip. (C)

11. Confirm solder melt of ALL joints, apply vacuum and lift component from PCB. (D) & (E)

12. Release component from tip by wiping on a heat resistant surface.

13. Re-tin tip with solder and return the SX-100 to its Tip & Tool Stand.

14. Prepare lands for component replacement.

PACE SensaTemp® or Intelliheat® Power Supply

SX-100 Sodr-X-Tractor®

TQFP Removal Pik-Tip® (See Chart on Back)

PS-90 Universal Soldering Iron or TD-100 Thermo-Drive®

Soldering Iron

Chisel or Conical Tip

Tip Maintenance Station

Tip Tool

Flux-cored Solder


Product Image Dimensions Part Number
A X B 8.2mm (0.322") x 8.2mm (0.322") 1121-0571-P1
A X B - 8.7mm (0.344") x 8.7mm (0.344") 1121-0572-P1
A X B - 12mm (0.472") x 12mm (0.472") 1121-0573-P1
A X B - 12mm (0.472") x 12mm (0.472") 1121-0574-P1
A X B - 13.2mm (0.520") x 13.2mm (0.520") 1121-0575-P1
A X B - 15.3mm (0.604") x 15.3mm (0.604") 1121-0576-P1
A X B - 16.8mm (0.660") x 22.9mm (0.900") 1121-0603-P1
A X B: 21.6mm (0.850") x 21.6mm (0.850") 1121-0604-P1
A X B - 22.1mm (0.870") x 22.3mm (0.870") 1121-0605-P1